CA Global SubSystem › Load a Compiled IMOD

Load a Compiled IMOD

Before you can execute a compiled IMOD, you must load it in a CA-GSS address space.

To load a compiled IMOD from the IMOD editor

1. Access the compiled IMOD you want to load.

   A list containing the required IMOD appears.

2. Enter P or F in the input field beside the name of the IMOD.

   The IMOD is in the correct status for loading.

   Note: For more information about the P and F command characters, see the online help.

   You can also change the status of an IMOD to prepare it for loading by using SRVMAINT and including the CHANGE batch maintenance command in your JCL job.

   Note: For information about how to use the SRVMAINT batch maintenance program, see Batch Maintenance of ISETs and ILOGs. For information about the CHANGE batch maintenance command, see the Reference Guide.

3. Specify the subsystem ID of the target CA-GSS/ISERVE address space in the SSNAME field at the lower right of your panel, and enter L beside the IMOD.

   The following message appears at the upper right of your panel:

   IMOD Loaded
   

   If the IMOD is already loaded, it is replaced.