CA-GSS/ISERV Commands › CA-GSS/ISERVE Operator Commands › RESET ILOG

RESET ILOG

Use the RESET ILOG command to make a full ILOG file available for use again.

Syntax

Use this format for the RESET ILOG command:

RESET ILOG file.subfile

Parameters

The RESET ILOG command takes these parameters:

file

Number of the ILOG file. Specify a value from 0 to 16 (inclusive).

subfile

Number of the subfile. Specify a value from 0 to 9 (inclusive).

Example

------------------------ CA‑GSS/ISERVE Control Panel --------------------------
==> reset ilog 0.2                                                     => PAGE
Target node: *                ssid: *    Host node: B1MAIN           ssid ISRV
==============================================================================
ILOG RESET

Other Responses

Invalid ILOG number: nn

The ILOG file number nn is not valid. nn must be between 0 and 16 inclusive.

Invalid subfile number: nn

The subfile number nn is not valid. nn must be between 0 and 9 inclusive.