CA-GSS/ISERV Commands › CA-GSS/ISERVE Operator Commands › Issue Commands From the CA SYSVIEW Performance Management ISERVE Interface Panel

Previous Topic: Increase the Size of the Command Input Area

Next Topic: ACTIVATE

Issue Commands From the CA SYSVIEW Performance Management ISERVE Interface Panel

To issue commands from the CA SYSVIEW Performance Management ISERVE interface panel, you use the same syntax that you would use if you were issuing them from an operator console. See the section Issuing Commands From an Operator Console for details. However, you must prefix the commands with "ISERVE" to distinguish them from native CA SYSVIEW Performance Management commands. For example:

ISERVE DISPLAY ACTIVE

For additional information, see the CA SYSVIEW Performance Management manual set.