CAIRIM Configuration › Customize CAISSF for RACF or RACF-Compatible Products › Install CAS9RACL

Install CAS9RACL

To install CAS9RACL

1. Edit the source member, CAS9RACL, in the CA Common Source Library, YourdeployHLQ.CAW0SAMP.
2. Locate the table identified by label RACLTBL.
3. Add the required CA solution classnames to this table as defined by your solution‑specific documentation.
4. Modify and Submit member CAS9CSSF in the YourdeployHLQ.CAW0JCL data set.

   CAS9RACL is installed when you submit CAS9CSSF. Read the JCL comments in CAS9CSSF for instructions on which steps should be executed to install CAS9RACL.

5. Add programs DFHSIP, CAS9LRAC, and CAS9RACL to the RACF authorized callers table, ICHAUTAB, for the RACLIST privilege only.
6. Define the CAS9LRAC program to your current startup and shutdown PLT for CICS using the following entry:

   DFHPLT TYPE=ENTRY,PROGRAM=CAS9LRAC
   

   Add the same entry to your PLT shutdown member, so all classes RACLISTed during CICS startup are deleted at shutdown.

   Sample PLT members S910PLT and S910PLTS are furnished in YourdeployHLQ.CAW0OPTN for reference.

7. Define the CAS9LRAC program to your current PPT for CICS using the following entry:

   DFHPPT TYPE=ENTRY,PGMLANG=ASSEMBLER,PROGRAM=CAS9LRAC
   

   A sample PPT member, S910PPT, is furnished in YourdeployHLQ.CAW0OPTN for reference.

8. Make program CAS9LRAC accessible through DFHRPL and CAS9RACL accessible through STEPLIB or LNKLSTxx of your CICS job control.

   CAS9RACL is installed.