|
|
|
The CAIENF parameters allow you to customize and control various aspects of the way CAIENF will perform its functions. Some of these parameter settings need to be done based on the requirements of the CA products that you will be running on the system. CA product CAIENF parameter requirements are covered in the software requirements sections in the specific CA product documentation.
Each CAIENF parameter is documented in CA Common Services for z/OS Reference Guide, in the CAIENF Chapter, in the Control Options section.
If any of the CA products that are running on the system perform CAIENF event recovery, these products will have instructions that require CAIENF event recording to be enabled (RECORD(YES) parameter). If event recording needs to be enabled, then ENF must be run with a CA Datacom/AD database. See the chapter Install CA Datacom/AD on preparing a CA Datacom/AD MUF and database for use with CAIENF. If event recording is not required, then the ENF parameter NODB can be set. NODB will instruct ENF to start without trying to establish a connection to a CA Datacom/AD MUF.
If you are upgrading from a CA Common Services for z/OS release prior to release 12.0, you can use a tool called ENFUTIL to help create the CAIENF control options that replace old CAS9DB functions that existed for CAIENF on releases prior to release 12.0. The ENFUTIL utility has been provided to create the DCM and EVENT control option statements starting with CAIENF release 12.0. This utility uses a CA Common Services release 11 DB detail listing as input. For Special DCM and EVENT Utility details, see the Reference Guide.
The ENFUTIL output file will be a list of CAIENF DCM and EVENT control options statements that will match the settings that used to be stored on the CAIENF database on CAIENF releases prior to release 12.0. These statements can then simply be placed at the back of the CAIENF parms file.
| Copyright © 2011 CA. All rights reserved. | Tell Technical Publications how we can improve this information |