CA-GSS/ISERV Commands › CA-GSS/ISERVE Operator Commands › DISPLAY CSECT

DISPLAY CSECT

Use DISPLAY CSECT to display the status of any CSECT in any load module in any library.

Syntax

Use this format for the DISPLAY CSECT command.

Display CSECT {STEPLIB module} [csect]
              {JOBLIB module}  [IMOD imodname]
              {dsname module}
              {dsname(module)}

Parameters

The DISPLAY CSECT command takes these parameters:

STEPLIB

Searches the STEPLIB data set.

JOBLIB

Searches the JOBLIB data set.

Dsname

Searches the specified data set. This data set must be cataloged and must be accessible (read access) to the user issuing the request.

Module

Name of the load module to be searched.

Csect

Name of the CSECT to be displayed. If omitted, the CSECT name is assumed to be identical to the load module name.

Imodname

Search for the CSECT that contains the specified IMOD. This parameter is valid for load modules created with the IMOD Packaging Facility.

Example

------------------------- CA‑GSS/ISERVE Control Panel ------ ROW 1 TO 4 OF 4
==> display csect ewf.fxao.authlib(test)                             => PAGE
Target node: *               ssid: *    Host node: B1EWF              ssid EWF
==============================================================================
Display for load module TEST in EWF.FXAO.AUTHLIB
CSECT TEST was assembled on 03/18/06 by version 02.01
Fix TEST021 was applied on 03/18/06
Fix NO_IDENT was applied on 03/18/06