Common Communications Interface › TCP/IP Configurations › Issue CAICCI TCP/IP Gateway Commands › TRACEON Command—Turn On Tracing

Previous Topic: SYSDTECT Command—Turn Sysid Detection On and Off

Next Topic: TRCROUTE Command—Turn Route Tracing Detection On and Off

TRACEON Command—Turn On Tracing

The TRACEON command turns on active tracing and writes it to one of the following: the system log, the console, the internal trace table, or to a specified ddname.

This command has the following format:

Traceon(,WTL | WTO | INT | ddname)
WTL

Writes the trace to the system log.

WTO

Writes the trace to the console.

INT

Writes the trace to the internal trace table.

ddname

Writes the trace to the specified ddname. If the ddname is not in the jobstream, it is dynamically allocated.