Resource Initialization Manager › Operation › Run CAIRIM as a Started Task

Run CAIRIM as a Started Task

You run CAIRIM as a started task unless an installed CA product requires CAIRIM to be run before JES.

To run CAIRIM as a started task

1. Make a copy of the CAW0PROC(CAS9) member.
2. Update the copy to suit the requirements of your site.
3. Move the updated copy to a system proclib.
4. Issue one of the following console commands:

   START CAS9
   

   START CAS9,,,AUTOCMDS
   

   START CAS9,,,EKGP
   

   AUTOCMDS

   Reissues all the commands specified by the AUTOCMDS DD statement.

   Note: Usually, CAIRIM only issues auto commands the first time it is run. This parameter forces auto commands to be reissued on subsequent startups.

   Important! Before using the AUTOCMDS parameter, you should check that reissuing the commands do not cause problems. The parameter can result in duplicate started tasks.

   EKGP

   Causes CAIRIM to prompt the operator to input a valid EKG LMP Key.

5. CAIRIM starts.