The Keys to scan tab on the Configure Reference System dialog specifies the registry keys to scan. During the reference installation of a product, the Packager checks for changes, and records changes in the registry of those areas specified on the Keys to scan tab.
If you do not specify a key on the Keys to scan tab, then changes made to the key during the reference installation will not be recorded, and, therefore, the key will not be reset to its original state after the reference installation is completed.
A key entry is interpreted recursively, which means, the Packager checks for changes below the specified key.
Specifying default keys on the Keys to scan tab is sufficient for most products.
The Packager detects:
Use the two preset main keys only. You do not need to specify other keys, because all other keys are sub keys of these two keys.
| Copyright © 2014 CA Technologies. All rights reserved. |
|