Creating Reports › About Reports › Move Report Information to a Data Set

Move Report Information to a Data Set

TSO deletes the spool‑resident data when it moves the data to the disk‑resident data set. The new data overwrites any data already residing in the disk‑resident data set. Be sure that you requested all of the report information that you want to include before you issue the TSO OUTPUT command.

To move report information

1. Exit your CA Auditor session.
2. Go to ISPF/PDF option 6, TSO Command Processor.
3. Enter the command:

   STATUS userid
   

   userid

   Your TSO user ID.

   The system displays the job information for your session:

   IKJ56211I JOB userid (TSU.xxxxxx) EXECUTING
   

   xxxxxx

   The job number for your TSO session. Make a note of this job number.

4. Enter the command:

   OUTPUT userid (Txxxxxx)PRINT(EXAMINE) CLASS(A)
   

   xxxxxx

   The job number for your TSO session noted in Step 3.

   CLASS(*) means CA Auditor uses the same class as the MSGCLASS of your TSO session.

   The report is moved to a disk‑resident data set. TSO does not display a message to confirm that the report was moved.

The reports are now stored in the data set:

userid.EXAMINE.OUTLIST

userid

Your TSO user ID.

EXAMINE

The name of the data set.

OUTLIST

The data set suffix that the OUTPUT command assigned to the data set.

Use ISPF/PDF option 1, Browse, to review this data set.