Installing Your Product from Pax-Enhanced ESD › Receiving the SMP/E Package › Prepare the SMP/E Environment for Pax Installation

Prepare the SMP/E Environment for Pax Installation

The members used in this procedure prepare the data sets, initialize the zones, and create the DDDEFs for CA Auditor.

For information about the members, see the comments in the JCL.

Follow these steps:

1. Customize the macro AUDSEDIT with your site-specific information and then copy the macro to your SYSPROC location. Replace the rightmost parameters for each ISREDIT CHANGE macro command. Each time you edit an installation member, type AUDSEDIT on the TSO command line, and press Enter to replace the defaults with your specifications.

   The macro is ready to customize the yourHLQ.SAMPJCL members.

   Note: Set the DASD HLQ to the same value specified for yourHLQ for the unzip to DASD ESD JCL.

   Note: The following steps include instructions to execute the AUDSEDIT macro each time you open a new SAMPJCL member. To edit all SAMPJCL members simultaneously, read and follow the instructions in the AUDEDALL member.

2. Open the SAMPJCL member AUD1ALL in an edit session and execute the AUDSEDIT macro from the command line.

   AUD1ALL is customized.

3. Submit AUD1ALL.

   This job produces the following results:

   • The target and distribution data sets for CA Auditor are created.
   • Unique SMPLTS, SMPMTS, SMPSCDS, and SMPSTS data sets for this target zone are created.
4. Open the SAMPJCL member AUD2CSI in an edit session and execute the AUDSEDIT macro from the command line.

   AUD2CSI is customized.

5. Submit AUD2CSI.

   This job produces the following results:

   • The CSI data set is defined.
   • The SMPPTS and SMPLOG data sets are allocated.
   • The global, target, and distribution zones are initialized.
   • The DDDEF entries for your product are created.
   • The DDDEFs for the required SMP/E data sets are created.