|
|
|
The CA Auditor installation program dynamically allocates each of the CA Auditor data sets on the disk volume identified by the VOLUME control statement. Additional space on that volume is required for temporary work areas and is released when the installation program completes.
You can use the ISPF/PDF Data Set List Utility to identify disk volumes that have adequate free space. The table following summarizes the CA Auditor data set space requirements by device type.
|
Non‑SMP/E Data Set |
SMP/E Data Set |
3390 Tracks |
|---|---|---|
|
CLIST |
CAJ0CLS0 |
5 |
|
DBASE1 |
CAIDBS1 |
165 |
|
DBASE2 |
CAJ0DATA |
75 |
|
LOAD |
CAJ0LOAD |
79 |
|
MESSAGES |
CAJ0MSG0 |
10 |
|
PANELS |
CAJ0PNL0 |
150 |
|
PROCS |
CAJ0PROC |
2 |
|
TABLES |
CAJ0TBL0 |
3 |
|
TNGMODS |
CAJ0OBTV |
3 |
|
Temporary Tracks for Installation |
|
44 |
|
Temporary Cylinders for Installation |
|
3 |
|
Total Tracks |
|
523 |
|
Total Cylinders |
|
35 (approximately) |
The amount of DBASE1 space needed depends primarily on the number of users and their use of the freezer and notes facilities. These estimates are approximate because service can affect requirements. You can free any unused space in any of these data sets except DBASE1.
| Copyright © 2011 CA. All rights reserved. | Tell Technical Publications how we can improve this information |