|
|
|
If you install CA Access Control using Solaris native packaging on all zones, CA Access Control also automatically installs on any zones you create after the original installation. However, while the post-installation CA Access Control procedure scripts need to run from within the non-global zone, for new zones, these scripts can only run once the new zone configuration is complete. Specifically, you must run the "zlogin -C zonename" command (which, completes the configuration of the name service, the root password, and so on).
Important! If you do not run the "zlogin -C zonename" command, or if you boot and log in to the new zone very quickly, CA Access Control installation will be incomplete as the post-installation scripts did not run.
Note: For more information on setting up a new zone correctly, see Sun's System Administration Guide: Solaris Containers--Resource Management and Solaris Zones, which is available at Sun Microsystems Documentation website.
| Copyright © 2012 CA. All rights reserved. | Tell Technical Publications how we can improve this information |