|
|
|
Installing on clusters is much the same as a standard installation. To configure CA ARCserve RHA on a cluster, enter the Virtual Server Network Name (or IP Address) resource (in the group you intend to protect) as the Master or Replica name. Do not use node names or IP addresses when configuring the scenario. Also, you must install the Engine to all cluster nodes (see Server Setup).
The only configuration that requires some preparation is the use of IP Move in conjunction with a cluster. For detailed instructions on how to use Move IP with clusters, please see Cluster Move IP.
Note: On Exchange Server 2007, LCR and SCC deployments are supported, but CCR and SCR deployments are not supported. Exchange Server 2010 no longer supports CCR, LCR, SCC and SCR.
| Copyright © 2012 CA. All rights reserved. | Tell Technical Publications how we can improve this information |