Introducing CA ARCserve Backup Agents and Options › Using Agents › Agent for Virtual Machines › Installing and Configuring the Agent › How to License the Agent

How to License the Agent

The CA ARCserve Backup Agent for Virtual Machines uses a count-based licensing method. You must register one CA ARCserve Backup Agent for Virtual Machines license for each host system and VM that you are protecting using CA ARCserve Backup. You must register the licenses for the agent on the CA ARCserve Backup primary server or stand-alone server.

Examples: How to License the Agent

The following list describes typical installation scenarios:

• Your environment consists of one Hyper-V host with three guest operating systems. You must register four licenses (1 host system + 3 VMs) on the CA ARCserve Backup server.
• Your environment consists of one VMware ESX Host system with three guest operating systems. You must register four licenses (1 backup proxy system + 3 VMs) on the CA ARCserve Backup server.
• Your environment consists of two Hyper-V host systems. Each Hyper-V host system contains three guest operating systems. You must register eight licenses (1 host system + 3 VMs, 1 host system + 3 VMs) on the CA ARCserve Backup server.
• Your environment consists of one VM host system (VMware ESX Host or Hyper-V Server) with two VMs. You require only raw (full VM) backups and will not specify the Allow file level restore option. In this scenario, you must install the agent only on the host system. However, one license for each VM must be registered on the CA ARCserve Backup server. Therefore, you must register three licenses (1 host system + 2 VMs) on the CA ARCserve Backup server.

Note: For more information about backup modes, see How Global and Local Backup Modes Work.