Using the Command Line Interface › tapecomp - Tape Compare Utility › tapecomp - Examples

tapecomp - Examples

The following are examples of syntax for the tapecomp command:

• Use the following command to compare all sessions on Tape1 in Source Group 0 to Tape2 in Destination Group 1:

  tapecomp -sGROUP0 -rTAPE1 -dGROUP1 -tTAPE2 
  

• Use the following command to compare all sessions from Session 3 on TAPE1 TEST in Source Group 0 with all sessions from Session 4 on target TAPE2 TEST in Destination Group 1:

  tapecomp -sGROUP0 -r"TAPE1 TEST" -n3 -dGROUP1 -t"TAPE2 TEST" -x4