The caadvreports command provides various options for generating advanced reports. The caadvreports command can accept and parse a variety of report parameters; however, not all parameters are required for all the reports. Based on the type of report that is being generated, only the parameters required and supported by that specified report will be used. Parameters that are not needed will be silently ignored.
To run any advanced report, you must specify at least the report type and the path of the file where the generated report will be saved. If one of the required parameters for a particular report is not specified, the utility will fail and the reason for failure will be entered in the log file.
The following report types, along with the corresponding supported filter parameters can be generated using the caadvreports command:
This report provides information on what percentage of backup attempts that are successful and also shows percentage of incomplete and failed backup attempts.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
This report provides information on what percentage of backup attempts that are successful on a per node basis.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
-Percent (Limit output to only include nodes with failure percent greater than the specified percentage).
This report provides information on what percentage of all restore attempts that are successful.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
This report provides information about the average throughput that is being seen on the drives.
-StartDate
-EndDate
-PastDays
-Serial (Limit output to only include drives with serial number matching the filter)
This report shows the number of errors and warnings generated for the backup job for each of the backup paths during the reporting period.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
This report shows the clients with the most failed backup attempts during the reporting period.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
-Top (Limit output to the top 'n' clients only)
This report shows the clients with the most consecutive failed backup attempts during the reporting period.
-StartDate
-EndDate
-PastDays
This report shows the clients with the most number of partial backups.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
-Top (Limit output to the top 'n' clients only)
This report shows the average backup time, average backup data, and average throughput for full backups of all backup paths during the reporting period.
-StartDate
-EndDate
-PastDays
-JobDesc (Limit output to only include jobs with matching description)
This report shows the status of last execution of all the backup jobs in the queue. If a job is still active, it shows the current status of the running job. This report only shows the status of the job in the queue at the time the report is generated.
None
This report shows the list of tapes that will move in or out of the vault on the day of reporting. You can use the -VaultCycle command to run the vault cycle before generating the report.
None
| Copyright © 2010 CA. All rights reserved. | Email CA about this topic |