|
|
|
Action diagrams record the basic constructs that make up a procedure. The action diagram is used to specify the procedural steps that make up a CA 2E function. These procedural steps encompass a list of actions; each action can either be a call to another function or a number of low-level built-in functions.
Depending on where you are in CA 2E, use one of the following sets of instructions to get to the action diagram of a function. These instructions are only provided here, in the beginning of this chapter. Other instructions in this chapter assume that you are already at the Edit Action Diagram panel.
When a parameter is being passed as an array there is a single subfile line that indicates an array being passed.
Note: If the called function’s parameter interface is modified to toggle the parameter Passed as Array field from Y to blank, the behavior of the EDIT ACTION – FUNCTION DETAILS changes accordingly to match.
| Copyright © 2011 CA. All rights reserved. | Tell Technical Publications how we can improve this information |