Agent Guide › Configuring the SiteMinder Agent, WebSphere-Side › Configure the SiteMinder TAI in WebSphere

Configure the SiteMinder TAI in WebSphere

You configure the SiteMinder TAI in the WebSphere 7.0 Application Server using the WebSphere Integrated Solutions Console. General information about enabling Web Trust Associations is available in the WebSphere documentation.

Note: WebSphere can support the coexistence of multiple TAI module implementations. The TAI implementation used is determined as follows: When a request is made for a WebSphere protected resource, the server calls the isTargetInterceptor () method of each TAI implementation one by one to determine which interceptor is going to handle the request until one responds. To enable the Web Trust Association between the SiteMinder TAI and the WebSphere Application Server:

To enable the Web Trust Association between the SiteMinder TAI and the WebSphere Application Server

1. If necessary, start the WebSphere Application Server and the WebSphere Integrated Solutions Console.
2. In the WebSphere Integrated Solutions Console, select Security, Global Security.
3. Under Authentication, expand Web and SIP security and select Trust association.
4. Under General Properties on the Trust association page, set the Enable trust association option.
5. Under Additional Properties, select Interceptors.
6. On the Interceptors page, click New.
7. Under General Properties on the New page, enter the following SiteMinder TAI class name next to Interceptor class name and click Apply:

   com.netegrity.siteminder.websphere.auth.SmTrustAssociationInterceptor
   

8. Click Apply to apply your changes. Click Save to save directly to the master configuration.

TAI-Only Configurations:

If you are setting up a SiteMinder TAI-only configuration, skip the rest of the procedures in this chapter and proceed to Verifying SiteMinder Agent Installation and Configuration.

More information:

Configure the TAI, SiteMinder-Side

Verifying SiteMinder Agent Installation and Configuration